1911Forum banner
10mm
1-5 of 5 Results
  1. Springfield Armory
    Hey everyone, New here. I’m picking up a new Springfield Ronin 1911 in 10mm today. I’ve been reading that the springs in some 1911’s can’t handle full power 10mm loads. I’ve tried to google, but can’t find any info. Does anyone know if the Ronin can handle full power 10mm loads, or do I need to...
  2. Rock Island Armory
    I’m new to this forum but not to 1911’s. Just picked up another of the RIA 1911A1 FS, Tactical's in 10mm at Murdocks Ranch store. They had ten (10) of them along with thirteen (13) of the RIA G.I. model …. On SALE! For 15% off! I don’t think I have ever seen more than two of either of these in...
  3. Kimber
    I always wanted a 1911 and the fact that I am taking a trip into bear country gave me cover to get one. I bought a 10mm Kimber Long Slide. I also bought some 220g hard cast bullets from Buffalo Bore. Wanted to see if others had used this or a similar combo. I talked with Kimber and they...
  4. Gunsmithing & Troubleshooting
    I just finished my first build using a 10MM/.40 S&W RIA kit, which unfortunately didn't include the reverse bushing and the ejector pin was faulty, so I put the gun together without the recoil spring, guide rod, and ejector just to get everything else fitted and try some function testing. Upon...
  5. Gunsmithing & Troubleshooting
    First off, any help greatly appreciated! I've been pondering over this for the past few days now. I'm building a CCO in 10mm and was planning to weld a Briley magwell. Part already in hand, ready to start milling away when I noticed the sear spring slot is almost at the same level with the MSH...
1-5 of 5 Results
Top