1911Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Recently, I had a Wilson high ride beavertail installed in my 1991a1. I've detail strippped the pistol for cleaning and after reassembling, the grip safety does not perform properly (it allows the hammer to fall without the GS being depressed). The thumb safety works properly. Where did I go wrong in reassembly? Any help would be appreciated greatly.

------------------
Matt
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
Thanks for the input. It feels like the grip safety is partially engaged, but when pressure is applied, the trigger bar slides past it. Thanks again for the help.

------------------
Matt
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top