1911Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
297 Posts
Discussion Starter #1
Here are some pics of my 2 new 1991's.
I've replaced the flat plastic MSH's with arched steel ones. Both MSH's were purchased used at a local gunsmith's, who collected them over the years from customizing old Colts. He charged me $5 each.
The medallion grips I bought on ebay.
The only other planned change is a Casull short trigger in one. If I like it, I'll do the other.
I love both these guns.
 

·
Registered
Joined
·
297 Posts
Discussion Starter #6
I'm so sorry everyone. You can see I'm a new member, and I can't seem to figure this out. I started this thread a few days ago, and could not get the pics to attach, so I just exited. I didn't think the post went through!! I was wrong. What am I doing wrong? Why can't I get the picture to attach?
 

·
Registered
Joined
·
1,139 Posts
Ok...just so there's something to look at....here's a pic of mine which sounds very much like yours....except the trigger is out of a Series 70...the grips are off a Series 70 (from Ebay) and the steel MSH is from a local gunsmith's "take off" box.

 

·
Registered
Joined
·
297 Posts
Discussion Starter #8
PLEASE TELL ME HOW TO PUT A PICTURE ON THIS THREAD :) :) :)
 

·
Registered
Joined
·
1,139 Posts
pbjk45 said:
PLEASE TELL ME HOW TO PUT A PICTURE ON THIS THREAD :) :) :)
Well there's this way

and then there's the other way...in which you can attach the pic to the post via the "Attach file" box when you post a message.
 

·
Registered
Joined
·
297 Posts
Discussion Starter #10
Lets try again
 

Attachments

1 - 12 of 12 Posts
Top