1911Forum banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
5,062 Posts
Discussion Starter · #1 ·
I have a Smith & Wesson Hand Ejector circa the 1930's chambered for 32-20 caliber. Could anyone tell me of any ammo manufacturers that factory load any hollowpoints for this caliber? All I can find is lead round nose and flat nose from Winchester and Black Hills. Thanks

[This message has been edited by Kimber45 (edited 09-29-2001).]
 

·
Premium Member
Joined
·
5,062 Posts
Discussion Starter · #2 ·
By the way, I'm not thinking about using for Self Defense, so don't worry. I have a very fine Kimber and a Glock .357sig for that purpose.
 

·
Registered
Joined
·
2 Posts
Since you have a Kimber, I'm wondering if their manual assertion that you must use at least 1.26 inches length bullets applies to Winchester USA 230 grain FMJ ammo? It is only 1.25 inches.
 

·
Premium Member
Joined
·
5,062 Posts
Discussion Starter · #4 ·
jluria, I'm not sure of your reply. My question was for .32-20 ammo, not .45acp. Thank you, though.

------------------
Double-action in an auto pistol seems to me an ingenious solution to a non-existent problem. -Jeff Cooper G&A mag Oct. 1973
 
1 - 4 of 4 Posts
Top