1911Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
121 Posts
Discussion Starter · #1 ·
Ok, perhaps I should try and rephrase my question. I recently placed a Charles Daly MS Field Grade Model. I would like to know if anyone could offer any advice specifically regarding holsters and grips that would fit this model. Thanks.
 

·
Registered
Joined
·
27 Posts
10EC.
The daly can use the same grips that fit a colt or any colt copy. I have a set of pachmayer grips off of a colt on mine right now. the screws are different but the grips interchange. I have a full size daly and it fits fine in several holsters made for the gov model colt. I would think your midsize daly would fit in any holster made for a comander size colt or colt copy.

therealkaos
 

·
Registered
Joined
·
249 Posts
i got some custom rosewood diamond grips. believe they were mccormick. make sure they are for ambi. had to do some nominal adjusting. boy, did they "spiff" up the look of the gun.
mcole
 

·
Registered
Joined
·
121 Posts
Discussion Starter · #4 ·
Thanks very much for the replies. Respects!

[This message has been edited by 10EC (edited 04-20-2001).]
 
1 - 4 of 4 Posts
Top