1911Forum banner
1 - 1 of 1 Posts

·
Banned
Joined
·
1,028 Posts
Hade a 2000 Loaded that I had to beat the slide off of with a 2x4 when I field striped it for the first time. The back of the slide was pinched tight to give the appearance of a tightly fitted slide. It was obviously done after assembly because it gouged a shaving out of the slideway of the frame. I could have lived with that because it was an accurate gun but the front sight started shooting loose. No FTF's or FTE's but that was only a matter of time judging by the dings in the brass. Given the cost of either shipping the gun back to springfield or paying a local smith to fix things, I opted for trading it on a 1991A1 Commander. Florida's instant check computer was down today so I can't pick it up till tomorrow.
I'll post a range report when I wring it out.

Elrod

[This message has been edited by ElrodCod (edited 09-09-2001).]
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top