1911Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
225 Posts
Discussion Starter · #1 ·
Anybody know where I can find a set that will fit in the stock cut-outs and won't cost me an arm and a leg? Night sights in the same configuration would be even better...
 

·
Administrator
Joined
·
74,658 Posts
Novak makes a drop-in tritium rear sight for the Kimber in the bar configuration to match the factory front. I have this setup on my Gold Combat Stainless. I'm not entirely sure I like the bar-dot setup, however.
 

·
Registered
Joined
·
105 Posts
Kimber can install them for you. They did a set for me, had the slide shipped back to me the same day they received it.
 

·
Registered
Joined
·
225 Posts
Discussion Starter · #5 ·
Thanks everybody for your responses. Unfortunately my new sights will have to wait a little while. While I was in the local gun shop this morning I found a used Colt Combat Elite for $500 and I just couldn't pass on a deal like that...





...I know.....I'm weak.....
 
1 - 6 of 6 Posts
Top