1911Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
421 Posts
Discussion Starter · #1 ·
BCP full house- I finally got it!





The beavertail and thumb safety are of Danes own design. Beavertail is quite different from any other that I know of and as you can see leaves no unsightly gaps under the frame, is tightly trimmed for size and does have a small contoured pad.

The mag pad shown is low profile and steel finished in hard chrome to match the frame.

CMC frame, Heinie Slant Pro 8s, BarSto, tool steel firing system, Videcki trigger, tulip wood grips, ect.


Regards,
Shay
 

·
Registered
Joined
·
195 Posts
I'm green with envy! Nice piece, how does it shoot?

How long did it take and how much did it cost ya? I just got my Custom Stainless from Kimber with a new frame and I was thinkin' about sending it to Dane for the FED plus extras but the wait is oh so long


Okay, I'm game, gun is on its way to Dane...

------------------
"Ain't nothin' like a finely-tuned 1911..."

[This message has been edited by Glock_Racer (edited 09-01-2001).]
 

·
Registered
Joined
·
421 Posts
Discussion Starter · #3 ·
Hey Glock_Racer,
cost on this Baby was $3200 with a little over a year wait. some of the wait is due to the finish process so the time depends on your choice of finish. Dane surprised me and added serrations on top of the slide at no cost asd with out me asking for it. i have never had serrations like that and it adds alot as far as following the front sight at rapid fire.
send that kimber and you wont be sorry.

regards,
shay
 
1 - 3 of 3 Posts
Top