1911Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
152 Posts
Discussion Starter #1
How hard is it to remove?.How do you remove it?.
 

·
Registered
Joined
·
53 Posts
barswaygo,


It is a fairly simple operation to remove the mag. disconnect. I had a hard time getting the taper pin out and ended up buggering up the frame on my Mk.III, but hey, just the excuse I needed to have it hard chromed!

Good info on this can be found on the Unofficial Hi Power Forum, or just ask Stephen Camp. His replies are gold.


lesthemess
 

·
Registered
Joined
·
152 Posts
Discussion Starter #5
Well I finally got it removed.Reinstalling the trigger was a little tricky though.The trigger pull is still very heavy,maybe it will get better after I shoot it some.Next on the list is to bob the hammer and install a single extended thumb safety.
 
1 - 5 of 5 Posts
Top