1911Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
87 Posts
Discussion Starter · #1 ·
This could be due to me taking my first gun apart to clean it. It did not seem so hard to asseble it. Some how the bullets do not load into the barrel. They stop at the end of the clip
 

·
Registered
Joined
·
130 Posts
I'm guessing maybe when you installed the slide stop shaft you didn't get it to go through hole in the barrel link. :scratch:
 

·
Registered
Joined
·
87 Posts
Discussion Starter · #3 ·
I hope your right

I was thinking the same thing. The link seemed like it was okay but I can't be for sure. I sent it back to Springfield under warranty. I pray that is the problem. It would make things so much easier
 
1 - 3 of 3 Posts
Top