1911Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
108 Posts
Discussion Starter #1

·
Registered
Joined
·
1,776 Posts
You can put LockTite on the outer bushing threads with the screws already in them. Tighten the bushings using the screw. Let set for an hour or so. Use slow, consistent pressure to loosen the screws and they'll break free easily and leave the LockTited bushing in place.

Edit: Since you have the bushing tool coming in, what I wrote is most useful if installing hex or torx grip screws, since they "cling" to the bit driver and there's no fumbling.
 

·
Registered
Joined
·
793 Posts
the bushings that are in place have loc-tite on them from Baer. If they give you grief place a sodering iron on the bushing for 5 mintues.
 

·
Registered
Joined
·
108 Posts
Discussion Starter #4
Thanks.....I kinda figured they put loc-tite on them.
 
1 - 4 of 4 Posts
Top