1911Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
174 Posts
Did the same conversion with a Kart EZfit. Really easy project with all the relevant parts usable. It does require a gunsmith to throat the barrel since it comes unthroated from Kart. The reason is to allow for accurate fitting of the barrel to the application. I mainly use 124 cast bullets so it was necessary.

Because of my load, I replaced the recoil spring with a 12 pound which pretty much fixed any ejection problems.

Very satisfying project and easy to switch back to 38 super if needed. FYI, the super mags work great with 9mm. However, I bought a couple of Springfield style mags. Both work great, I will probably buy more super mags when I buy more.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top