1911Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
122 Posts
Discussion Starter · #1 ·
I would like to convert my full size tac .45 ambi safety to the standard GI single safety. What parts would I need? Just the safety (#4541)?
 

·
Registered
Joined
·
3,058 Posts
I would like to convert my full size tac .45 ambi safety to the standard GI single safety. What parts would I need? Just the safety (#4541)?
Yes. But you'll need a unmodified sear pin (#4538) for $3.95 as well
 

·
Registered
Joined
·
808 Posts
Is the ambi-safety setup on your FS II in good condition (still tight together, don't care about the finish really)?

If they are I'd buy your ambi setup, including the retention pin, to offset the costs of your new parts.

PM me if you are interested in getting rid of them.
 

·
Registered
Joined
·
122 Posts
Discussion Starter · #6 ·
Thanks for offer. I will keep the original parts in case I decide to put it back to stock. The gun is brand new.
 

·
Registered
Joined
·
5,116 Posts
Is the ambi-safety setup on your FS II in good condition (still tight together, don't care about the finish really)?

If they are I'd buy your ambi setup, including the retention pin, to offset the costs of your new parts.

PM me if you are interested in getting rid of them.
I often see them on the Buy-Sell forum here.
 
1 - 9 of 9 Posts
Top