1911Forum banner
1 - 1 of 4 Posts

· Registered
275 Posts
I have used rifle brass (.348 Winchester?) to make .445 Supermag. I won't do that again.

Cutting is easy, except that the length changes when you resize. Inside reaming is a pain, and not possible to get concentric.

You need a lathe-type reaming tool and some way to cut the brass to length, plus the sizing die(s).

[This message has been edited by KLN (edited 09-07-2001).]
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.