1911Forum banner
1 - 9 of 9 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Could someone please tell me the height (thickness) of the mounting feet on the Dillon XL 650? I want to have the proper length mounting hardware in hand before my new press gets here. Thanks.
 

·
Registered
Joined
·
14,968 Posts
I didn't want to raise my 650 as high above my bench as the Strong Mount provides, so I made a mount two pieces of 5/8" plywood sandwiched and just a little larger in length and width than the 650's footprint. The 650 needs about 1" or so of overhang from the front face of the bench, if the Strong Mount is not used.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #7 · (Edited)
WESHOOT2,

At what temperature was that .775" measurement taken? And was it taken before or after torquing of the bolts and compressing that pretty blue powder coat?!?!

Just kidding............Thanks for the info.
 

·
Registered
Joined
·
56 Posts
The base of my example is .814. The strong mount thickness is .1245. All measurements taken over paint finish. Torque values and temperature on request. :biglaugh:
 
1 - 9 of 9 Posts
Top