1911Forum banner
1 - 3 of 3 Posts

· Registered
419 Posts
Discussion Starter · #1 ·
Hopefully this pic from photopoint will work this time...If not I sure would appreciate some help from Jaydee..dsk...moderators...

It was a $600 Kimber and off to the smith it went...

All of the internals were replaced...
and then 30lpi front strap was added
3lb trigger job
Ed Brown wide ambi grip safety
ED Brown memory groove beavertail
Feed reliability tune up
EGW fiber optic front sight
Briley mag well
Novak low mount rear sight
EGW slide stop - polished
Ed Brown hardcore extractor
Wolff 16# variable rate recoil spring
MGW commander hammer
EGW sear
Frame hardchromed
Fitted EGW barrel bushing
Videki match trigger

This gun was custom fitted by Precision Gunworks Canton, Ga

John Harrison Gunsmith

I tested it out today and it shot a 1.5" group @ 25 yards in the rain...in the first group...I can't wait to take my time and see what it does... http://albums.photopoint.com/j/View?u=1643870&a=13757511&p=54143055&Sequence=0&res=high[/img]

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.