1911Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
513 Posts
Discussion Starter #1
As you look at the index holes on one of my magazines, the upper right corner has a tiny bit of plastic peeling back a bit. Underneath the little piece is steel. Should I:

1. Glue it back down;

2. Break it off;

3. Leave it alone, or;

4. Trash the magazine (which seems extreme to me).

Thanks!
 

·
Registered
Joined
·
5,043 Posts
In order.

1. The plastic used won't glue. Forget it.

2. Break it off if it's not too big, or will cause further peeling.

3. Leave it alone as long as it doesn't come loose and cause problems.

4. Don't trash it. If it causes problems, use it for a practice mag.

5. Send it back to Glock and ask for a replacement.
 

·
Registered
Joined
·
74 Posts
Just trim the plastic with some nail clippers or wire cutters as long as it's just a small amount of plastic that's peeling. If it's a large amount, contact Glock for a replacement.
 

·
Registered
Joined
·
513 Posts
Discussion Starter #5
Thanks to all of you.

Ben
 
1 - 5 of 5 Posts
Top