1911Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
416 Posts
Discussion Starter #1
I was cleaning my SR1911 CMD this morning (I love to clean guns almost as much as shooting them) and noticed my grip screws were loose. I got my Allen wrench set out and found out that the smallest one was to small and the next size to big. My wrench's are not metric. So, I guess I need a new set of wrenches (metric size)??????
 

·
Registered
Joined
·
80 Posts
If one is to big and the next size you have is to small, then get the size between the two. Ran into the same problem and I believe the 3/32 was the size needed.
 
1 - 8 of 8 Posts
Top