1911Forum banner
1 - 1 of 1 Posts

186 Posts
Discussion Starter · #1 ·
S.A. 1911-A1 standard parts

Problem #1
If the trigger is squeezed gently (as it should) the hammer falls on the half-cock notch before it goes all the way and strikes the firing pin. I figure it couldn’t be good. How do I fix?

Problem #2
After decreasing the pressure of leaf spring (by banding the fingers) the hammer now follows the slide down (don’t now if this means full auto) what caused this, how do I fix?

Gun Control = hitting your target
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.