1911Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
276 Posts
Discussion Starter · #1 ·
I need a new frame for my Springer and sent an e-mail message requesting a quote from Fusion. Here is my e-mail request to Fusion:

I have a 2007 Springfield Lightweight Champion Operator and would like to get a new Fusion Frame.

Please quote the following:

New Carbon Steel Frame with 25 LPI front checkering
Pro Series Trigger group with combat hammer
Beavertail grip safety
S/A MSH with Magwell flat 25 LPI Checkering
Single side safety
Single side mag release
Red Cocobolo checkered grips
Slide to frame fitting
Finish to match Armory Kote Springfield finish. Or close…
I’m looking for a complete lower frame.

And here is Bob's response:
Hi Jeff:

New Carbon Steel Frame with 25 LPI front checkering (Complete built $495)
Pro Series Trigger group with combat hammer
Beavertail grip safety
S/A MSH with Magwell flat 25 LPI Checkering ($24 upcharge) if you use ours no extra charge...
Single side safety
Single side mag release
Red Cocobolo checkered grips $25
Slide to frame fitting $65
Function, feed and test fire $18
Refinishing Yukon coat $70 ( includes dehorning etc...)

Total $$697

For the quality of these parts I thought this was a very reasonable quote, especially when the response comes in one day from the OWNER...

I beleive these guy's are going get my business!!!
 

·
Registered
Joined
·
7,459 Posts
+1 to Bob. Tracy
 

·
Registered
Joined
·
211 Posts
If your experience turns out...

Like mine, you'll be thrilled with what you get from Bob and Fusion. He thus far from what I have seen around has some of the best prices out there. Would love to see what ends up in your hands if you end up going with Fusion.
 
1 - 5 of 5 Posts
Top