1911Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
8,648 Posts
Discussion Starter #1
Greetings from a long-time Tampa-area resident. Hey, wondering if you've seen the thread over at General Discussion regarding the P-13 vs. Kimber. Another member reports that he and several of his shooting buddies have each had several parts failures in their P.O.'s, while I've never had a single part fail. I shoot only .45, while I believe he and his buds are shooting P-16's. What's you experience here? Thanks.

------------------
Make It Hot!
 

·
Registered
Joined
·
855 Posts
I haven't had those kinds of problems with my Para's. But I,ve had a trigger job, with sear and hammer replaced, on my P16 with an Ed Brown grip safety added. The only problem I had with the P16 was a feeding problem when new. GunCraft in Ruskin is a warranty station for Para, so I took it there. They polished the feed ramp and checked out my magazines. No problems since then.
 
1 - 2 of 2 Posts
Top