1911Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
118 Posts
Discussion Starter #1 (Edited)
Hi, I need to thin down a frame so that a mag catch is flush on the right side (it sits too deep), the frame is .764 wide, what was the spec of the original frame width? I thought it was .750 but I'm usually wrong, I need to remove .010.
 

·
Registered
Joined
·
1,514 Posts
a new mag catch might be a better solution. some might be a hair wider than the one you have. or the one you have might be just a little too short. This may be a prime example of tolerance stacking, the frame is at the upper limits, while the catch is at the lower limits.
 
1 - 3 of 3 Posts
Top