1911Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
787 Posts
Discussion Starter #1
I need an Officers 9MM barrel bushing. The exterior of the barrel at the muzzle is .696". I can't locate one to fit. Any Ideas? Thanks JP
 

·
Registered
Joined
·
382 Posts
Bushing

If you've got the old one, measure the length of the part
that fits in the slide and have a machinist cut a regular one
down to that length. If the bushing fits the slide too loose
put a ball peen hammer in the back end and hit it with
another hammer to spread it out and make it fit tighter.
A friend did it when I needed a bushing for my commander
and it worked good.

C-Buff
 

·
Registered
Joined
·
787 Posts
Discussion Starter #3
Need a new one.

I need a new one. The slide and barrel came without one. JP
 
1 - 4 of 4 Posts
Top