1911Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
773 Posts
Discussion Starter #1
I'm not sure if this part exists, but I'd love to find a guide rod plug for a FLGR that doesn't have a sharp edge all the way around so the gun could be disassembled easily by hand. Basically, leave some additional material where the bushing would otherwise overlap the plug on one side, and make that the "bottom" side of the plug. That would give you a place to push on the plug for disassembly.

Does anyone make this part?
 

·
Premium Member
Joined
·
2,130 Posts
Check out our monogram bushing set
that will be kinda like what your asking for.

or
we can make a one off plug like your asking for to work with a std bushing.
EZ press spring plug or something like it. :)

thanks
geo

www.egw-guns.com
 
1 - 5 of 5 Posts
Top