1911Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
691 Posts
Check out VZ grips

I'm not sure about the website address, but check out the grips from VZ Grips. They make some of the grips that Wilson sells (with the Wilson medallion in the center) so they might make the G10 grips too. (Specifically they make the grips that are currently on my CQB: Black Linen Micarta) Between the checkering on the frontstrap and the mainspring housing, and the checkering on the grips, I think I am good to go unless the gun and I are completely coated in oil.
 

·
Registered
Joined
·
47 Posts
Springfield has those grips available. Identical to yours without the logo as well. They are standard equipment on the TRP.
 

·
Registered
Joined
·
81 Posts
I have purchased 4 sets of the Horned Lizard Grips from Larry Davidson at http://www.davidsonknives.com/grips/grips.htm

I have a set on my 2 bobtails, my EMP and my Tac Pro II that has a mag well. He will make them the way you want them. I asked him to cut a hole for the mainspring housing pin for my bobtails since I liked the look of the Ed Brown Grips...no problem at all.

jhbsce94
 
1 - 8 of 8 Posts
Top