1911Forum banner
1 - 2 of 5 Posts

· Registered
23 Posts
Discussion Starter · #1 ·

I recently bought some 7 round mags.
This is the one: http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=677564

The mag followers moves forward and backward and it´s almost impossible to release the slide with the slide stop when having an empty mag in the gun.
(The follower hangs up on the front edge of the magazine, if i pull the follower a little backwards I can manuver the slide release/stop.)
Now im a little afraid that the followers will damage the ramp.
The gun is a SA Mil-Spec so it has no aluminum frame. (I can see a tiny mark on the ramp tho but that´s from the original mag since I havent used the new ones yet)

Is there any aftermarket follower in plastic that will fit those mags?
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.