1911Forum banner
1 - 3 of 3 Posts

·
Banned
Joined
·
1,350 Posts
Discussion Starter · #1 ·
How do you get that little double spring apart on the 3" micro? I think its past time to re-spring that litle sucker. Guide rod (assembly?) comes out fine, but I cant seem to get the second spring apart. The first spring comes off ok (little hard to reassemble) but the smaller, inner spring guide doesn't want to come apart. Manual doesn't seem to have what I need. Help?
 

·
Banned
Joined
·
1,350 Posts
Discussion Starter · #3 · (Edited)
:scratch: So, to replace the small spring, you replace the whole thing? Seems kind of silly. I saw a post about a FLGR in a champion. Does anyone make one for a micro? any probs with reliability? Single spring vs. double spring? Edit: Ok, Called the factory (when all else fails, read instructions) and they said they sell a replacement assembly for $35. Seems like a new FLGR and Spring would be cheaper in the long run ($15-18 per spring , i'm guessing), but would it be better? Anyone?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top