1911Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 · (Edited)
Ejector on CDP? On the locked thread they just about had me convinced that mim/forged/machined barstock were all about the same as far as relia bility goes. Then I was cleaning my 200 to 250 rounds fired CDP, low and behold I found a broken ejector.:mad: :grumble: :bawling:
What should I replace it with? Wilson:cool: , Ed Brown:hrm: , Kimber:D .
 

·
Registered
Joined
·
381 Posts
dottie,

The ejector or the pistola?:biglaugh:

Larry C.

(P.S.- I'll never own another Kimber)
 

·
Premium Member
Joined
·
20,434 Posts
I'm partial to Ed Brown Hardcore parts, but the Wilson Bulletproof line is great also. I'd never replace a defective part with the same one!
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #5 ·
AZ Husker said:
I'm partial to Ed Brown Hardcore parts, but the Wilson Bulletproof line is great also. I'd never replace a defective part with the same one!
The Kimber option was a joke, Hence the :D following it. Was leaning toward Wilson myself. Thanks for the replies.
 

·
Registered
Joined
·
1,251 Posts
AZ Husker said:
I'm partial to Ed Brown Hardcore parts, but the Wilson Bulletproof line is great also. I'd never replace a defective part with the same one!
just because one broke dont mean they all will...that being said i would probibly use the Brown...
 
1 - 6 of 6 Posts
Top