1911Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,264 Posts
Discussion Starter · #1 ·
Hi Jim,
I recently got a new computer. Everything is fine, but when i go into the moderator section it recognizes and accepts my codes on the staging page but pops me back to the staging page as if i were in a loop so i can't get in. Any ideas?

Thanks-
Gali
 

·
Registered
Joined
·
9,203 Posts
Gali, you don't need me, you need someone like SUPER.
LOL
Son, can you help Gali with this?

I'm going to close this thread here and transfer it to SUGGESTIONS.

------------------
Ne Conjuge Nobiscum
Molon Labe

[This message has been edited by Jim V (edited 03-03-2001).]
 

·
Registered
Joined
·
1,264 Posts
Discussion Starter · #4 ·
Hi Son,
I've been so busy I've just been popping ing and out lately...I'll try it now.

Thanks

Galileo
 

·
Registered
Joined
·
1,264 Posts
Discussion Starter · #5 ·
Hey Son,
LOL...I was really freaked-out a minute ago because i went to the original thread after posting my last reply to you only to find the thread was closed without either post. I neverf paid any attention to where the post was when i replied through the email link.

Anyway, after digging through my email trash i found it again a re-clicked...here I am


So...I tried the cookie thing and it didn't work. Very strange problem since nothing else, either here or any other web-site, has a problem.

confused but not worried-
Gali
 
1 - 5 of 5 Posts
Top