1911Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
187 Posts
Discussion Starter · #1 ·
I made a solid recoil spring guide for my Sig P6 out of 4142 steel, I cant wait to get the new breech block pins in the mail so I can try it out next trip to the range. Don't laugh at my cold blue job it was a learning experience!
 

Attachments

·
Registered
Joined
·
7,818 Posts
The main question will be, Does It Work?

If it does, Good Job.

Anyone that wants to criticise you?

Have them make a better one.
 

·
Registered
Joined
·
187 Posts
Discussion Starter · #4 ·
Thanks I got the rest of the gun, I have been shooting this Sig with a broken outer breech block pin, lol but I cant make roll pins!
 

·
Registered
Joined
·
187 Posts
Discussion Starter · #5 ·
The main question will be, Does It Work?

If it does, Good Job.

Anyone that wants to criticise you?

Have them make a better one.
it should work the material used was pre-hardened to 32'ish Rc, dimensionally everything is the same within .017" on OAL and .001" on diameter, not worried about it working worried about how long it will last
 
1 - 5 of 5 Posts
Top