1911Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hello Everyone, first off I just want to say I am very pleased with my new Panther stainless. I did have a minor problem with FTF (failed to feed) were the slide would come forward and pinch the new round before it could seat in the barrel. After 300 rounds it seemed to work itself out of that little problem. Now however I have seemed to have stripped the alen headed set screw on the rear sight. I think I can get it loose but does anyone know what size I need for a replacement? Or maybe I should go with a 3 dot sight set up... Choices, choices. :D

Thanks for any and all input,

jay
 

·
Registered
Joined
·
844 Posts
Jay, The screw is a 4-40 these are standard in the XS sights shipped on the gun. The dovetail cuts for the rear sre a standard .495 X 65 DEG and .330 X 60 DEG front. So replacement sights are easy to find if you are looking for night sights ect..

Thanks,
Bob
DWF:)
 
1 - 2 of 2 Posts
Top