1911Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
224 Posts
Discussion Starter · #1 ·
I maxed out the vertical adjustment screw on the rear sight of my Elite LS Hunter. Nice quality sight but at 20 yards with the height adjusted all the way, it's shooting about 2-2 1/2" low. Does someone make a longer screw that I could install? Another 1/16" in height would probably do it I believe.
 

·
Registered
Joined
·
115 Posts
Stop. Punt. Go to the other end and replace the front sight, with a shorter one. Shorter front sight gives you a higher point of impact. I don't like my rear sight to high. Adjustable rear sights are not the toughest and the higher you run them, the easier they are to break.
 
1 - 3 of 3 Posts
Top