1911Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
22 Posts
Well 1st off u need some dies i'd go with Lee carbide dies for 45acp. Next u need a press. i'd go with a kit because that comes with most everything u need except powder, primmers, brass, and bullets. There r a couple other things u need that aren't in the kit. Depends on how much $$$ u want to spens Lee is a good starter set. RCBS is 150$$$ more because with a little more stuff, and i think a little bit better build stuff. i would also pick up a dial caliper to measure the overall lenght of the ammo. hope this helps u out
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top