1911Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
How much hassle is it to reload .357 Sig. Cal.? I have only reloaded streight wall cases in the past. Do I need case lube and additional tools for full length sizing, or
just carbide dies? Any advice positive or negative would be appreciated. Thanks!

Mike

------------------
 

·
Registered
Joined
·
263 Posts
realoading 357sig is like reloading for a rifle, you have to use lube, dillon does make carbide dies, but they are pointless if you doing it single stage. you have to worry about case set back a lot, so using lead, or canalured bullets is almost a must. not super hard, but very different than reloading strait walled handgun cartriges.

------------------
Any gun will do if You will do.
 

·
Registered
Joined
·
1,384 Posts
Moving to Reloading Bench.

------------------
"Of those that will penetrate, the edge is always with the bigger bullet."
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top