1911Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a Remington Model Seven 300 Saum. After it is fired I am having problems cycling my spent hulls back out. Any idea where to start or what may be wrong. I has been sent back to Remington once.
 

·
Registered
Joined
·
247 Posts
Check the extractor maker sure its not broken, next make sure no rough spots in the chamber then check head space. I had a Kimber 8400 in 270 WSM that could close on a no-go, when shot the case would get stuck in the chamber.

JB
 

·
Registered
Joined
·
189 Posts
It may not be the gun. I would first clean the chamber correctly. If either you haven't cleaned it in a while, or it sat on the shelf at the dealer and that crappy packing oil dried in there(we try to rotate our guns so the olders get sold first). Had trouble with a rem 700 I bought for my wife and a real good scrub sequence with a CHAMBER brush worked it out. If you got it used, 95% of people don't even have a chamber brush so the chamber never gets cleaned...:(
 
1 - 3 of 3 Posts
Top