1911Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
I've been trying to figure out how to disassemble/remove the plastic grip on my SVI. I couldn't find any direct info on this in my manual or on SVI's website.Does anyone know if there's an online guide to taking off the grip or could tell me what steps to take in doing it? Thanks
 

·
Super Moderator
Joined
·
739 Posts
Remove all the other parts from the lower end first then remove the top screws from the grip on both sides (the big screws) then you will have to tap out the grip screw bushing . Take a punch and tap the bushing towards the inside of the grip, it should fall in fairly easily. Then take two hex keys and remove one of the small screws at the front of the triggerguard. You can then tap out the sleeve holding the other screw out the other side. Once you have removed screws and bushings hold the grip and tap the frame gently with a plastic mallet or piece of wood at the front and back of the frame until it comes off.
 
1 - 3 of 3 Posts
Top