1911Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,426 Posts
Just a suggestion from a machinists point of view. Why grind the whole side of the slide off? An endmill slightly larger in diameter that the offensive marking is tall will remove it and leave an oval depressed area that is perfect for engraving a logo or other marking. Just tram the slide level, drop the endmill down at the beginning of the lettering and move it to the end, leaving a shallow slot with round ends.
________
(________)

Some polishing required and watch the depth!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top