1911Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3,078 Posts
Originally posted by RonS:
Just a suggestion from a machinists point of view. Why grind the whole side of the slide off? An endmill slightly larger in diameter that the offensive marking is tall will remove it and leave an oval depressed area that is perfect for engraving a logo or other marking.
Personally, I prefer that the slide look flat. An oval depression would not look good in my opinion.

YMMV Thanks for the input!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top