1911Forum banner
1 - 1 of 1 Posts

·
Premium Member
Joined
·
7,292 Posts
I'd be happy to surface grind your slide to remove all rollmarks.
Usually the cocking serrations are below flush enough to not be touched.
If necessary, I can grind it, avoiding the serrated area. Surface grinding produces a dead flat, good finish, approximately equal to a surface produced by 320 grit sandpaper.

Chuck
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top