1911Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
192 Posts
Discussion Starter · #1 ·
I half detail stripped my new CD last night. I took everything out of the frame except the sear pin/sear/disconnector. Once removing the hammer, I looked in an along the inside of the frame near where the trigger bar runs it had surface rust. This is on the left side of the frame. The gun is blued. Should I be concerned about this? It doesn't seem like it would be good? I'm new to taking apart guns, but this gun is just so simple to dissasemble. Any ideas?
 

·
Premium Member
Joined
·
939 Posts
Hi jfr, lightly buff it with some 0000 steel wool to remove the rust and oil, the bad thing is, once steel starts rusting it wants to keep rusting, but this will keep it under control.

------------------
Metal Smith

The only thing I know for sure is what I can measure!
NRA Life Member
 
1 - 3 of 3 Posts
Top