[Haycreek]

Have you any advice or warnings related to replacing the original sear and hammer assymblies with Chip McCormmick or Brownell's parts. This is on a Colt series 70 that I purchased new. If I make these changes, I likely will also replace other parts as well[trigger,new springs et at] the pistol is in excellent condition as is, I just want to make some improvments.Thanks for your comments.

------------------

 

[Raspy]

<><> Hmmmmmm, how do you improve
on excellence?
------------
<><> Raspy <><>

 

[RickB]

I put a McCormick hammer/sear set in a Norinco, and it amounted to a $30 trigger job. I prefer premium parts, but bang-for-the-buck, the cheaper parts are a good value.

 

[spyder]

RickB,

I'm looking at putting a hammer, sear, and disconnector from Chip in a Sistema. When you say $30 trigger job, was it good or bad? I'm new to 1911's so any and all advice is welcomed.

spyder