1911Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
58 Posts
Discussion Starter #1
All,

I posted this under the gunsmithing area as well and hopefully someone can help. A friend of mine has a S&W 469 that he is putting a new set of grips on. In order to install the grips the backstrap must be removed. He asked for my help but I've never had to remove a backstrap before, but it looks like all that has to be done is drive out the pin at the bottom of the grip. But it also looks like the hammer spring is anchored by that pin. Will we mess something up by driving the pin out without doing something else?

Thanks for any advice!
 
1 - 1 of 1 Posts
Top