1911Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
Picked up a set of really nice thin micarta checkered grips by Navidrex from Brownell's. With the help of some generous folks here I found slotted blue thin screws and bushings.

The problem is the slotted thin screws do not countersink into the grips holes and while they fit, they are too tall and raised well above the grip surface.

Would thin hexheads be the ticket to mount down in the grip ?
 
1 - 1 of 1 Posts
Top