1911Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I detail stripped my sistema to install new springs and to clean it good. Now I cannot get the S&D installed back correctly. I have stripped it and reassembled it 7-8 times. The sear keeps hanging up on the half cock notch. I have Kuhnhausen's book and the NRA publication that shows the disassembly og the gun. I simply can not get it right. If anybody can offer any help, please do. tia
 

·
Registered
Joined
·
5 Posts
Discussion Starter · #3 ·
The hammer falls only to H/C. Cocking the gun is no problem but when I pull the trigger the hammer falls to H/C only.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top