1911Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
563 Posts
Piece of cake, Dude! Put the sear and disc. in the gun and pin it. Install the hammer and pin it. Lay the sear spring on these parts and capture it with the mainspring housing. Slowly slide the mainspring housing up and capture the hammer strut and bring the hammer back to full cock. Insert the grip safety and pin it with the thumb safety and pull the trigger letting it fall all the way down. Pin the mainspring housing. Shoot the gun but load only one in the mag. Then two. Then 7. The trick is to make sure that all THREE FINGERS of that spring are on top of something. Not UNDER something. The right finger is waving in the breeze waiting for the grip safety, of course. The middle finger is on the disc. slope, and the left finger is on the sear. Hope this helps.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top