1911Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I fired my Pre-Enhanced MS model for first time yesterday and had only one problem. The slide would lock in the open position halfway through the magazine. Has this happened to anyone else? What is the Fix?

Yoshii
 

·
Registered
Joined
·
362 Posts
Try new magazines. I hear the Chip McCormick and Wilson work best.

You may want to try to figure out what is engaging your slide stop. It normally is the follower on the magazine. In your case, it may be ill-fitting magazines, or even a loose or ill fitted slide stop.

Hope this is helpful, I'm sure others will chime in with solutions as well.

[This message has been edited by ehenz (edited 10-25-2001).]
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
Thanks Ehenz...

I ordered a new slide stop yesterday after recomendation from my Gunsmith. If that does not work I will look into replacing the magazines. I appreciate your response.

Yoshii
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #4 ·
Figured the problem out... I tried some new Chip Mcormick magazines and had no problems at all. Must have been the loading spring

Yoshii
 
1 - 4 of 4 Posts
Top