1911Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
745 Posts
Esmeralda would..

I don't know if she carries square bottom slim grips in inventory, but for sure she would make you some if she doesn't...she is very attentive to customer satisfaction and requirements.
I know what you mean, I have slim-line Alumagrips on a Springfield with a Magwell, and it just doesn't look right. I also do not care for notching out for the mainspring housing pin in the bottom corner, don't see the need for that.
 

·
Registered
Joined
·
325 Posts
Ahrends makes some beautiful ones, make SURE to read the order instructions very CLOSELY - ambi-cut is a Standard Grip, grips without the ambi-cut are Non-Standard (+ $10) - configs include thin with short screws included, flat bottom for mag well, no notch for MSH pin, bob tail, and any combo of above - they will also hand pick for your prefered color etc.

http://ahrendsgripsusa.com/1911.htm
http://ahrendsgripsusa.com/orderprices.htm
 

·
Registered
Joined
·
271 Posts
Alumagrips makes grips for use with magwells (flat bottom). They even make them for the Wilson clip-on magwell.

Below is a pic of my SA Pro with the Alumagrips.
 

Attachments

·
Registered
Joined
·
60 Posts
www.ergogrips.net makes a slim-feeling grip that allows you to retain your normal screws and bushings. Significantly skinnier feeling, and functional, although not great for your "barbecue" gun. vzgrips makes spectacular stuff, and looks good, too.
 
1 - 10 of 10 Posts
Top