1911Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
221 Posts
Discussion Starter #1
This might be a stupid question and yes, I did read the how-to on this site.

My only thing is, I only bought the MSH and no other parts. Don't I need other stuff to make this work?

I know is even more of a dumb question but I am new to these guns. Is this the pin I need to punch out to remove the actual MSH?



I'm guessing I do all the steps in the how-to and knock that roll pin out to remove the MSH. After that, can I just install the Ed brown MSH W/Well? then re-pin it and I am good to go?

Thanks,

Dan
 
1 - 2 of 2 Posts
Top