1911Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
333 Posts
Discussion Starter · #1 ·
I had it with SA's low quality. They are POS period. There is a very good reason why they are made in Brazi. It's not because SA cares about quality, it's so they can increase their profit margin. My next 1911 will be the XS or XSE. I was dumb to buy a SA. I guess there is a sucker born everyday to keep SA going.
 

·
Registered
Joined
·
333 Posts
Discussion Starter · #3 ·
The entire gun was warped, or wavy. The rear sights came loose after a few rounds. Rust was already forming on the front of the trigger guard. The front of the slide was rubbing against the dust cover, which may be due to the warp issue.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top