1911Forum banner
Cancel

Tap Dimensions for grip bushing?

1163 Views 2 Replies 2 Participants Last post by  Roger D, 
R
I've been replacing stock Colt Grips w/ the slim/thin Chip McC.'s rosewoods. On one of my Series 80's Colts, one of the bushings was simply sitting (tighly) in the Frame - the hole IS NOT TAPPED (so much for Colt quality control in 1985)! Does anyone know the tap/thread dimensions so that I can get the grips installed properly?

Thanks & regards,


Roger
Save Share
Reply Quote
1 - 3 of 3 Posts
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
1911Forum
A forum community dedicated to all 1911 firearm owners and enthusiasts. Come join the discussion about optics, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
General Gun Discussion Gunsmithing & Troubleshooting Colt Springfield Armory Reloading Bench
Top